Proximity Sensors
Inductive sensors from a φ3 mm barrel to an M30 40 mm long-range body, plus capacitive, ring, flat-pack and square types.
Ultra-Thin Flat Inductive Proximity Sensors (5 – 10 mm thick)
A 5 mm thick slab with the sensing face on the flat: bolts to a gripper finger, a conveyor edge or the inside of a channel where no barrel fits.
View product page →
Ultra-Short Inductive Proximity Sensors (15 – 28 mm body)
A 15 mm long barrel where a standard 45 mm body has nowhere to go — measured from the face, not from the thread.
View product page →
Ultra-Compact Inductive Proximity Sensors (φ3 to M6)
Barrels from φ3 mm up, for the places where nothing else fits: inside a small fixture, beside a gripper jaw, or under a 10 mm strip of sheet metal.
View product page →
Standard Inductive Proximity Sensors, Short Barrel (M6.5 – M30)
The short-body standard: M6.5 to M30 with a 35 – 58 mm barrel, sensing 1 mm to 15 mm, in cable or M5-connector versions.
View product page →
Square-Type Inductive Proximity Sensors (5 × 5 to 17 × 17 mm)
A block instead of a barrel, with the sensing face on the front or on the top — the shape that fits against a flat plate, inside a channel, or under a moving
View product page →
Loop-Shaped (Ring) Inductive Proximity Sensors (6 – 21 mm bore)
A coil around a hole: anything metal that passes through is counted, down to a 0.4 mm wire, regardless of where in the bore it passes.
View product page →
Long-Range Inductive Proximity Sensors (2 – 40 mm)
Two to four times the sensing distance of a standard body in the same diameter: 40 mm from an M30, 20 mm from an M18, 10 mm from an M12.
View product page →
High-Temperature Inductive Proximity Sensors (M8 – M30, PTFE face)
A PTFE sensing face and a heat-tolerant coil for positions next to a hot platen, a pre-heater or a dryer hood, where a standard PBT face softens and drifts.
View product page →
Standard Inductive Proximity Sensors with Dual-Colour Indicator (M8 – M30)
The general-purpose block: eight body sizes from M8 to M30, sensing 1 mm to 25 mm, with a red / green status LED you can read from across the cell.
View product page →
DC 2-Wire Inductive Proximity Sensors (M8 – M30)
Two wires in series with the load — no separate supply wire, and any number of them can be connected in series into one PLC input.
View product page →
Capacitive Proximity Sensors (M8 – M30, 1 – 30 mm)
Detects what an inductive sensor cannot: plastic, glass, wood, grain, water and powder, up to 30 mm from an M30 body.
View product page →